H1010 Low Profile

Pavement must be cut to the dimensions as shown. 

Minimum 65 Horsepower saw is recommended for making pavement cuts. 

The saw is to be filtted with grouping of 18″ diameter saw blades with spacers, nested between 20″ diameter saw blades with spacers as recommended by saw blade manufacturer. 

Each pavement cut must be inspected prior to epoxy/marker installation per the following: 

•   Each casting must be centered lenghtwise and should have 1/8″ side-toside clearance after insertion in pavement cut 

•  All 4 leveling lugs must contact the pavement surface

•   The extreme ends of all castings must be belw pavemnt surface after insertion in pavement cut 

The pavement cut must be completely dry and free of dust, dirt or any other material that will interfere with the adhesive bond

2-component epoxy adhesive is to be used to fill the pavement cut to within 3/8″ of top of pavement. The place marker into the expoxy filled pavement cut-nthing 4 tabs must be in contact with pavement surface, and epoxy should be level with pavement surface. Epoxy should be prevented from blocking the reflector lens 

Any epoxy inadvertently spilled/dripped on the active reflector face must be removed immediately